Software Input/Output Guide X11 Administration ... - paulmick.com

LD 15
Alphabetical list of prompts Page 321 of 1050
Prompt Response Comment Pack/Rel
RECD (NO) Malicious Call Trace Recorder is not activated emct-20
YES Malicious Call Trace Recorder is activated
Not prompted when defining a new customer.
REF0 xxxx DN for Reference trunk 0 basic-1
REF1 xxxx DN for Reference trunk 1 basic-1
REF2 xxxx DN for Reference trunk 2 basic-1
REF3 xxxx DN for Reference trunk 3 basic-1
R_ENTRY aa
Xaa
Xaa Xbb
ANI entry for an incoming route to be created or
modified
ANI entry for an incoming route to be deleted
ANI entries for an incoming between aa and bb to be
deleted.
Exit
This prompt is repeated until is entered as
response.
ANI entries must be between 0 and (R_SIZE-1).
For REQ=NEW, only default table 0 is configurable.
An R-ENTRY can be deleted even if still configured on
an incoming route.
REQ: Request
In Release 21, a colon following a prompt indicates
enhanced processing. Enhanced processing allows a
user to either view a list of possible responses or input
an abbreviated response.
? Get a list of possible responses (Release 21 & later)
CHG Change existing data block
END Exit overlay program
NEW Add new data block to the system
OUT Remove data block
With X11 Release 23, the REQ prompt will appear
under the NET: Networking gate opener and the
following responses will be valid with respect to the
DPNSSI Message Waiting Indication feature.
cist-24
basic-1
dmwi- 23
X11 Administration