Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 391 of 1050
Prompt Response Comment Pack/Rel
OPDL (0)-8064 Outpulsing Delay, in milliseconds pra-14
If required for JDMI, OPDL = 3000 milliseconds.
Prompted when DGTP = DTI2 or JDMI.
OPE (NO) YES Change data port or operating parameters basic-18
Prompted only if TKTP = R232, R422 or MCU.
OPP (NORM) Operator originated calls receive normal treatment for
busy and intercept situations
ATT Operator originated calls routed to attendant for busy
and intercept situations
OPR (NO) YES Outpulsing Route
All trunk members for an OPR must have DTN CLS,
unless they are on Route 31 or Private Line Routes.
When RPA = YES, the default is YES.
Prompted with Outpulsing of Asterisk “*” and
Octothorpe “#” (OPAO) package 104, and prompted
when TKTP = COT, DID, FEX, TIE, or WATS.
OTL (NO) YES CDR on Outgoing Toll calls
If answer supervision is defined for the trunk, CDR
records will only be generated on call completion.
Prompted when OAL = NO and Route = CAMA, CO,
DID, FX, or WATS.
mfc-15
opao-10
cdr-1
OUT_T306 0-(30)-T306 Outgoing T306 timer value
T306 is the variable timer for received DISCONNECT
messages on outgoing calls. This T306 allows in-band
tones sent by the network to be heard.
This timer is stored in 2 second increments. Listed
below are region-specific T306 values:
bri-20
APAC region T306 max value (in seconds)
Australia 60
China 30
Hong Kong 30
Indonesia 30
Japan 30
Malaysia 30
New Zealand 30
Singapore 30
Thailand 30
X11 Administration