Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts Page 455 of 1050
Prompt Response Comment Pack/Rel
CNI s p g Core to Network Interface card location. To OUT a
CNI card, it must be hardware disabled and located
in the inactive CPU.
For Option 81:
s = slot 8-12; p = port 0-1; g = group 0-4
If only one CNI card is equipped, only one network
group is supported because one CNI card must be
installed in slot 8 in the Core Module and because
Port 0 must be configured as “group 5.”
Only Port 1 can support a network switching group.
To support two network groups, two CNI cards are
required. To support three network groups, only two
CNI cards are required because one port is available
in slot 8 and two ports remain available on the
second CNI card.
For Option 81C:
s = slot 12-14; p = port 0-1; g = group 0-4
Both ports (0 and 1) can be used to configure
network switching groups for card slot 12. No CNI
cables are required for port 0 of card slot 12.
basic-21
CNTY Country supp-10
(ETSI) ETS 300 =102 basic protocol
AUS Austria
AUST Australia
CHNA China basic-23
CIS Commonwealth of Independent States euro- 23
DEN Denmark
DUT Holland
EAUS Australia eurro-24
EIR Ireland
ESP Spain
FIN Finland
FRA France euro- 23
GER Germany
HKNG Hong Kong
INDI India isdn-24
INDO Indonesia basic-23
ITA Italy
JAPN Japan UIPE based interface basic-23
MSIA Malaysia basic-23
X11 Administration