Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 405 of 1050
Prompt Response Comment Pack/Rel
SCR (NO) YES Selective Carrier Restriction to restrict Equal Access
calls
New Flexible Code Restriction is enabled. NTOL and
ITOL must both be ALOW. Not prompted for Release
20 and later.
SEIZ ic dc Seize failure threshold. Where:
• ic = increment count = 1-(2)-31
• dc = decrement count = 1-(2)-31
SEIZ specifies the percentage threshold of trunks
which request seizure but are not seized (either no
response from the far end or response is too late).
See prompt ILLR for a description of ic and dc values.
The default for AID trunks is 2 1. The default for RAN
and MUS trunks is 12 6.
eqa-19
basic-1
SGL Signal for Release 10 and later: mfe-10
(NO) Return normal MFE signal
YES Return MFE idle signal
Signal for Release 9 and earlier: mfc-9
(NO) Return normal MFC signal and corresponding tone
YES Return MFC idle signal and corresponding tone for
Busy, Overflow, Congestion
SGRP (0)-999 Scheduled access restriction group
Prompted with Scheduled Access Restrictions (SAR)
package 162. Must have group defined in LD 88.
sar-20
pra-15
SID 0-511 Service Identification for the route
Used to poll switches for traffic, ACD or CDR reports.
Allows NSF to be turned on or off. The service route ID
must match the far end.
In Release 17 there is no default. In Release 16 the
range is 0-127 and the default is the route number.
Prompted if NSF = YES and TKTP = TIE/WAT/FX/COT.
X11 Administration