Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 363 of 1050
Prompt Response Comment Pack/Rel
The CTYP is used by the receiving switch so that it can
associate a call with a call type and perform ESN
access code insertion. This option only applies to direct
dialing using trunk access codes. NARS and BARS
dialing do not apply here.
If you intend to respond YES to prompt ISAR, use the
default for this prompt. If ISAR = YES, then CTYP
prints UNWN and does not permit you to enter a
response.
CUST xx Customer number associated with this route as defined
in LD 15
DCD Data Carrier Detect
(ON) Data Carrier Detect lead follows state of lead on device
to which it is connected.
OFF Data Carrier Detect lead forced active.
Prompted if TKTP = R232 or MCU.
basic-1
DCDR (NO) YES Include DNIS number in CDR records dnis-19
For Release 19 and later, this prompt appears for ISDN
routes to support Network ACD.
DCH 0-159 D Channel number isdn-16
DCHI 1-15 DCHI Port Number. Prompted when MODE = ISLD. pra-12
DCHI Port number must be defined in LD 17
DCNO (0)-254 Day IDC tree number idc-12
DCTI (0)-511 Time, in seconds, that an extension is allowed to ring or
be On-Hold or Call Park before the trunk is
disconnected.
Respond with a value equal to the number of seconds a
set is to ring after recall, plus the value of the Call Park
Recall Timer. The Call Park Recall Timer is defined in
LD 50 in response to the CPTM prompt.
Default or means that the condition goes on
indefinitely. The value stored - which will be the closest
lower multiple of four - is echoed back upon entry.
X11 Administration