Software Input/Output Guide X11 Administration ... - paulmick.com

Prompts and responses Page 341 of 1050
- - MDTD 1-(5)-31 Minimum Dial Tone Detection delay in seconds
- - DTDF x y Dial Tone Detector Fail threshold
- - SCDT (NO) YES Secondary Dial Tone detection will be used on route
- - 2 DT (NO) YES Secondary Dial Tone
NEDC aaa Near End Disconnect Control (aaa = ORG or ETH)
LD 16
FEDC aaa Far End Disconnect Control (aaa = (ORG), ETH, JNT, or FEC)
CPDC (NO) YES SL-1 is the only Controlling Party on incoming calls
SPCT aaa Speech Path Cut-Through (aaa = (IMM) or DLY)
DLTN (NO) YES Dial Tone on originating calls
- TOV (0)-3 Data Time-out Value
- PSEL aaaa Protocol Selection (aaaa = (DMDM) or TLNK)
- OPE (NO) YES Change data port Operating parameters
- - PSDS (NO) YES Public Switched Data Service option
- - TRAN a...a Transmission mode (a...a = (ASYN) or SYN)
- - PAR a...a Parity for data port (a...a = (SPAC), EVEN, MARK, or ODD)
- - DTR (OFF) ON Data Terminal Ready
- - DUP aaaa Duplex for data port (aaaa = (FULL) or HALF)
- - DCD (ON) OFF Data Carrier Detect
- - MOD (NO) YES Mode for synchronous operation
- - INT (OFF) ON Interworking
- - CLK (OFF) ON Clock source for synchronous operation
- - V25 (NO) YES V.25 bis option for synchronous operation
- - HDLC (NO) YES High Level Data Link Control
- - DEM aaa Data Equipment Mode (aaa = (DCE) or DTE)
- - PBDO (OFF) ON Port Busy upon DTR Off
ANDT (NO) YES Automatic Number Identification Dial Tone
HOLD ic dc ht Hold failure threshold
SEIZ ic dc Seize failure threshold
RGFL ic dc Ring Failure threshold
RVSD ic dc Reversed wired CO trunk threshold
ILLR ic dc Illegal Ring threshold
SVFL ic dc Supervision Failure
OPCB (NO) YES Operator Call Back
- IMBI (NO) YES Perform Immediate Break-In on this route
- IMCB (NO) YES Perform Immediate Call Back on this route
X11 Administration