Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 419 of 1050
Prompt Response Comment Pack/Rel
TIE AUTO Automatic TIE trunk data block opcb-14
TIE TONE Tone TIE trunk data block opcb-14
WAT Wide Area Telephone Service trunk data block basic-18
TOBO Toll Operator Break-Out. TOBO is prompted if
DTRK = YES, DGTP = DTI2, MFC = YES and
OPCB = YES.
(NO) OPCA signals received after a toll operator break in
operation will be ignored.
YES An OPCA signal received after a toll operator break-in
operation has been completed, will result in the toll
operator being removed from the call.
pedm-18
TOV Data Timeout Value basic-18
(0) No timeout
1 15 minutes
2 30 minutes
3 60 minutes
Prompted if TKTP = R232, R422 or MCU.
TRAN (ASYN) Asynchronous Transmission mode basic-18
SYN Synchronous Transmission mode
If PSDS = YES, then TRAN must be SYN. Prompted
if TKTP = MCU.
TRMB (YES) Tromboning allowed. Incoming call on route may be
routed directly back out on the same route.
NO Tromboning denied. Incoming trunk call on route may
not be routed directly back out on the same route.
Only applies to calls routed using NARS/BARS or CDP.
Does not apply to calls redirected by HUNT, Forward All
Calls, or Forward No Answer.
tat-21
X11 Administration