Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 458 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
CSQO (20)-255 Maximum number of call registers for CSL/AML
output queues
These call registers are used for Command and
Status Link applications such as Meridian Link.
Set CSQI and CSQO equal to the larger number of
either:
1. ACD agents or AST sets to be controlled by
the host computer, or
2. 50.
Do not set CSQI and CSQO to a number exceeding
25 percent of the total number of call registers.
553-3001-311 Standard 6.00 June 1999
cls-7
CTYP Card Type (Input/output port card type) msdl-18
CPSI Call Processor card (Option 81)
DCHI D-channel Interface card
ESDI Enhanced Serial Data Interface
ELAN AML over Ethernet card
MSDL Multi-purpose Serial Data Link (for Downloadable
D-Channel on Option 11)
MSPS Misc./SDI/Peripheral Signaling card
PTY Pseudo TTY (Option 81)
SDI Single port SDI card
SDI2 Dual-port SDI card
SDI4 Four-Port SDI card
SPDC Single Port DCH card
SDI4 Four port SDI card
TMDI D-Channel configuration on TMDI (NTRB21) card basic-24
XSDI SDI paddle board
Note: CTYP may printout as being set as QSDI from
previous software, but CTYP must be set to SDI4 when
configuring data.