Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 508 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
FIL This is a special response which applies to Alarm
Filtering message output.
553-3001-311 Standard 6.00 June 1999
When a port is assigned this User type, only Alarm
Filtered messages will be output. The messages
listed at the TRIGGER prompt are the messages
that appear for this user type.
When AF_STATUS = OFF, no system messages are
output to the port with FIL type.
The output appears as shown below. The field
definitions follow.
Operator data:
Expert data:
Where:
severity:
• **** = Critical
• *** = Major
• ** = Minor
• blank = None
report id: The system message character string
(BUG1234, ERR5683, etc.)
time: hh:mm:ss
date: dd/mm/yy
sequence number: The sequence the message
appears. The range is 0-65535, and the numbers are
right justified. Meridian 1 and auxiliary processor
messages have separate sequence numbers.
event: This indicates the type of event that is being
output: MSG (message), SET (set alarm), CLR
(clear alarm).
alarm-19