Software Input/Output Guide X11 Administration ... - paulmick.com

LD 11
Alphabetical list of prompts Page 169 of 1050
Prompt Response Comment Pack/Rel
PSEL Protocol Selection, DM-DM or T-link arie-18
(DMDM) DMDM is used by Meridian 1 data devices such as
ASIM, AIM, ADM, SADM, Asynchronous Data Option or
ADO, and MPDA. MCA can use both protocols.
TLNK TLNK protocol is used by SL-100 and DMS data devices
This prompt appears if DTAO = MCA, or TYPE = MCU
PUTYP Portable Subscriber Type uwin-24
(PRIV) Private
PPU Privateand Public Use
RCO (0)-2 Ringing cycle option for Call Forward No Answer uscr-18
This prompt appears when CLS = FNA or MWA (or both)
REQ: Request
In Release 19, a colon following a prompt indicates
enhanced processing. Enhanced Processing allows a
user to either view a list of possible responses or input
an abbreviated response.
? To get a list of possible responses (Release 19 and later)
CHG Change existing data block
CPY 1-32 Copy or create 1 to 32 new station data block(s)
automatically from the specified station data block.
Option 11 model sets cannot be copied.
END Exit overlay program
MOV Move data block from one TN to another. MOV is not
valid on Option 11 models.
MOV PAIR Move voice TN and data TN data blocks on NT8D02
Digital Line Card
NEW Add new data block to the system
OUT Remove data block
Before removing an ACD agent telephone, first remove
the associated AGT key on the supervisor’s telephone.
Select OUT and then NEW when switching resources
between virtual and actual ACD DNs, to avoid unwanted
information on ACD-D reports.
basic-19
X11 Administration