Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 470 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
HOST (NO) YES Enable HOST mode Log In for password PWnn.
When a HOST user logs in, the outputs defined for
the port are only output to that port. For example,
two ports are defined by prompt USER to output
BUG and SCH messages. When a HOST user logs
in to one of these ports, the other port does not
require BUG and SCH messages until the HOST
user logs out.
This removes the restriction that ports with the same
output must operate at the speed of the slowest port.
This feature is primarily used by applications such as
Meridian Manager.
553-3001-311 Standard 6.00 June 1999
lapw-17
HPIB 16-1000 High-Priority Input Buffers basic-19
16-5000 High-Priority Input Buffers for System Options 51C,
61C, 81 and 81C.
Recommended for attendant consoles and DID/TIE
trunks. High priority line or trunk cards are placed in
slot 1 and assigned have CLS = HPR in LD 10, 11,
12 or 14. Superloops do not require any line or trunk
cards assigned as high priority.
Refer to Appendix 553-2201-151.
HRLR (0)-8, 32-40 Handsfree Receive objective Loudness Rating
The HRLR value is downloaded to Meridian Modular
telephones after sysload, except when performing a
parallel reload. Refer to the Transmission parameter
and International loss and level plan NTP’s before
adjusting this value.
The default is 0. The number entered in this field
corresponds to an offset value. The offsets and their
corresponding values are provided on page 444.
hfdl-20