Software Input/Output Guide X11 Administration ... - paulmick.com

Page 436 of 1050 Gate Opener: PARM (System Parameters)
Gate Opener: PARM (System Parameters)
The following values should be set at the factory. However, it is
recommended that these values be reviewed during initial system installation.
Prompt Response Comment
REQ CHG Request
TYPE PARM Change system parameters
- LPIB 96 -5000 Low-Priority Input Buffers (range depends on system type)
- RCAP aaa Remote Capabilities (RCAP options begin on page 494)
- HPIB 16 -5000 High-Priority Input Buffers (range depends on system type)
- 500B 16 -5000 Output buffers for single line and digital telephones, and
trunks (range depends on system type)
- SL1B 16-2048 SL-1 Buffers
- RPEB 16 -1000 Remote Peripheral Equipment Buffers, 2.0 Mb/s RPE
- DTIB (35)-1000 Digital Trunk Input Buffers
- DTOB (4)-100 Digital Trunk Output Buffers per Digital Trunk Signaling Link
- NCR x...x Number of Call Registers, range depends on system type
- MGCR 0-NCR Maximum number of Call Registers used by AUX
messaging
- CSQI (20)-255 Maximum number of Call Registers for CSL input queues
- CSQO (20)-255 Maximum number of Call Registers for CSL/AML output
queues
- AXQI (20)-255 Size of Auxiliary Input Queue
- AXQO (20)-255 Size of Auxiliary Output Queue
- TRNS aaaa Selects which messages are going to be translated
(aaaa = (NONE), HELP, or BOTH)
- NCPU x Number of CPUs (aaa = 1 or (2))
- CFWS (NO) YES Call Forward Saved on SYSLOAD
- PCML aa Pulse Code Modulation Companding Law (aa = (MU) or A)
- ALRM (NO) YES Minor Alarm displayed on attendant consoles
- ERRM aaa Error Messages (aaa = ERR, BUG, or AUD)
- DTRB xxx Digitone Burst time in ms (xxx = 50, 60, 70, or (100))
- ABCD (NO) YES 16-tone DTMF operation enabled
- TMRK xxx Length of cadence increments in ms (xxx = 96 or (128))
- FCDR aaa Format for Call Detail Recording (aaa = (OLD) or NEW)
- PCDR (NO) YES Priority to CDR
553-3001-311 Standard 6.00 June 1999