Software Input/Output Guide X11 Administration ... - paulmick.com

ADAN DATA SAVED
ADAN DATA CHGED
ADAN DATA OUTED
ADAN DATA MOVED
LD 17
Configuration Record 1 Page 425 of 1050
Note: The ADAN DCH MOVE command allows primary D-channels
to move to a new card type (CTYP), device number (DNUM), and port
designation (PORT) when adding MSDL cards. You do not need to
remove any D-channels or B-channels when using this command with
MSDL cards.
The MOVE capability does not apply to Application Module Links (AMLs).
Move AMLs from ESDI cards to MSDL cards by adding a new AML with
the VAS ID prompt (VSID), then remove the old AML.
— When adding a D-channel, the parameters defined for the primary
D-channel are automatically copied to the backup D-channel. Changes to
the D-channel pair should be made to the primary D-channel.
— When changing a D-channel, the existing parameters are printed before
prompting you for the changes.
— DROL is updated to include Option 81 maintenance LDs 135 and 137 in
the midnight routines.
Conversion notes for Release 18
When converting to Release 18 from an earlier release the existing I/O ports
are affected as shown below:
— Existing AML CSL and DCH ports keep their device number and are
given an equivalent logical number and a card type or CTYP of ESDI or
DCHI. For example: CSL 9 becomes AML 9 with device number of 9
and CTYP of ESDI; DCH 13 becomes DCH 13 with device number of
13 and CTYP of DCHI.
— Asynchronous QPC513 ESDI ports are removed from the database. See
SYS4464.
— ESDI ports on DCHI cards are converted to TTY ports with CTYP of
DCHI.
X11 Administration