Software Input/Output Guide X11 Administration ... - paulmick.com

LD 14
Alphabetical list of prompts Page 221 of 1050
Prompt Response Comment Pack/Rel
TGAR (0)-15 Trunk Group Access Restriction: Release 1 to 13 basic-1
(0)-31 Trunk Group Access Restriction: Release 13 to 21
Where (0) removes existing restriction.
0-(1)-31 Trunk Group Access Restriction
The default of (1) automatically blocks direct access.
TIMP Termination Impedance. Prompted if XTRK = XEM
or XUT.
(600) 600 ohms
900 900 ohms
1200 1200 ohms
Use 1200 ohms for RAN trunks and (600) or 900 for all
others.
When using the Enhanced Universal Trunk card with
Release 19, only 600 or 900 ¾ terminating impedance is
allowed. However, more Terminating and Balance
impedance (BIMP) combinations are available.
The terminating and balance impedance options are:
TIMP BIMP
600 600
600 3COM
900 3COM
900 900
900 3CM2
600 3CM2
For XUT trunks, the Termination Impedance or TIMP must
be compatible with the Balance Impedance or BIMP.
The following combination of BIMP/TIMP are allowed:
Timp Impedance Bimp Impedance
600 ohms 3-component or 3com
900 ohms 3-component or 3com
600 ohms 600 ohms
1200 ohms 600 ohms
For XEM trunks, TIMP must be set to 600.
When CLS = JDID, TIMP must be set to 600.
tip/xpe-19
TKID nnnnnnn Trunk Identifier basic-6
Does not have to be unique. Default is no trunk identifier
assigned.
X11 Administration