05.02.2013 Views

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

LD 17<br />

Alphabetical list of prompts Page 453 of 1050<br />

Prompt Response Comment Pack/Rel<br />

0-10 SDI, LSL or PTY Option 11 Card number<br />

Expansion cabinets only support one TTY port which<br />

is on the Fibre Receiver Pack. When CAB = 1 or 2,<br />

CDNO is not prompted.<br />

Pseudo TTY does not belong to any card. When<br />

TTY_TYPE = PTY, CDNO is not prompted.<br />

1-9 AML application Option 11 Card number<br />

basic-20<br />

CEQU (NO) YES Change to Common Equipment parameters basic-1<br />

CFWS (NO) YES Call Forward Saved on SYSLOAD and reactivate on<br />

<strong>com</strong>pletion. To save information, set CFWS = YES.<br />

CLID (NO) YES Calling Line ID in the CDR<br />

If CLID = NO, “XXXXXXXXXXXX” will be printed in<br />

CLID field of CDR record. Prompted when<br />

CDR = YES and the Integrated Services Digital<br />

Network (ISDN) package 145 is equipped.<br />

OPT0 Prefix = 0 for North American dialing plan. OPT0 is<br />

the default for ESIG and ISIG interfaces.<br />

OPT1 Prefix = 1 for international PFXs in CLID. Any<br />

numbering type is supported. OPT1is the default for<br />

all EuroISDN interfaces.<br />

OPT2 Prefix = 2, for international PFXs in CLID.<br />

CCITT numbering types supported are: UKWN,<br />

INTL, NPA, and NXX. OP2 is the default for CO/DID<br />

routes for the Tele<strong>com</strong> New Zealand interface.<br />

OPT3 Prefix = 3 for international PFXs in CLID. Only the<br />

NXX number type is supported. OPT3 is the default<br />

for TIE routes for the Tele<strong>com</strong> New Zealand<br />

interface.<br />

OPT4 For international COs, if the call originates from a<br />

CO trunk type, add nothing. Otherwise, add PFX1<br />

and PFX2. OPT4 is the default for all Asia Pacific<br />

interfaces.<br />

basic-20<br />

pri-12<br />

euroisdn-2<br />

2<br />

<strong>X11</strong> <strong>Administration</strong>

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!