Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 373 of 1050
Prompt Response Comment Pack/Rel
SPN Special number
ICNT is prompted if table type of MFCI = R2MF
and ICIS = YES. ICNT is prompted if CLID entry
for ICDN = 0-125.
ICOG Incoming and/or Outgoing trunk basic-1
IAO Incoming and Outgoing
ICT Incoming only Trunk
OGT Outgoing only Trunk
ICPS Incoming Presentation Status mfc-22
(YES) Provide Trunk DN
NO Do not provide Trunk DN
ICPS is prompted if table type of MFCI = R2MF and
ICIS = YES. ICPS is prompted if the CLID entry for
ICDN = 0-125.
ID (0)-9 Identification digit for CAMA trunk routes cama-1
IDC (NO) YES Incoming DID Digit Conversion on this route idc-12
IDEF Internal/external definition basic-22
(NET) Use network information to define a call as internal or
external. Calls over the selected route will receive a
network treatment as defined by available network
information.
LOC Use local data to define a call as internal or external.
Internal calls will receive an internal treatment if
RCLS = INT. External calls will receive an external
treatment if RCLS = EXT.
IDEF is prompted in LD 16 if IDEF = YES in LD 15.
IDOP (NO) YES Identify Originating Party supp-10
Call Detail Recording for Internal calls to identify
forwarding station originating party.
Prompted when CFWR = NO
IDTB 0-7 ID table index to be used by this Meridian 911 route m911-19
IEC 001-999 Inter-Exchange Carrier ID pra-12
Precede with X to remove entry. If no value is entered
“???” is printed in the route data block.
Prompted when TKTP = COT, FEX or WAT.
X11 Administration