Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts Page 493 of 1050
Prompt Response Comment Pack/Rel
PWD2 x...x Password 2
Enter current second level administration password.
This password is required to change existing
passwords PWD1, PWD2, LAPW passwords and to
change the Electronic Brandlining Terminal Text
Broadcast customized text string.
Valid characters are 0-9, A-Z and a-z. Length is 4-16
characters with Limited Access to Overlays (LAPW)
package 164.
Without the LAPW package, the password requires
4 hexadecimal digits (0-9, A-F).
PWnn x...x Password
Length is 4-16 characters with Limited Access to
Overlays (LAPW) package 164. Valid characters are
0-9, A-Z and a-z.
Where: nn = number entered in response to LAPW
prompt.
Enter the LAPW password to be used for PWnn.
Note: If the LAPW password is a Set Based Administration
(SBA) password (PWTP=SBA), the PWnn response length
is 4-16 numeric characters, where the valid characters are
digits 0-9 only.
basic-1
lapw-16
PWTP (OVLY) OVLY Password Access Type adminset-21
SBA SBA Password Access Type
QCHID This rule is applicable for both encoding and
decoding of Channel Identification IE
(YES) Timeslot values 17 to 31 of the PR12 loop
associated to channel number 17 to 31 of the
Channel Identification IE (pervious behavior)
NO Timeslot values 17 to 31 of the PR12 loop
associated to channel number 16 to 30 of the
Channel Identification IE
RADR 0-(1)-255 Remote Address for the data-link level HDLC
protocol
The IADR and RADR prompts must be coordinated
with the far-end. If IADR is defined as 3, then RADR
must be 1.
qsig gf-24
cls-7
X11 Administration