Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 394 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
POST RAN Post announcement treatment ran-1
DIS Disconnect after maximum repetitions
ATT Route to attendant after maximum repetitions
PRDL (NO) No Partial Dial timing on DID routes supp-10
YES Partial Dial timing is equipped using EOD
BSY Busy signal is sent on time-out
PRIM (YES) NO Primary isa-12
PRIM represents the ISA route class of use. PRIM
determines whether the ISA route is the Primary or
secondary choice for calls accessing the service route.
PRIM is not prompted in Release 16 and later.
PRIV (NO) Route is not a Private line route basic-14
YES Route is a Private line route
Up to Release 13, used only on route 31. In Release 14
and later, any COT route can be a private route.
Prompted if TKTP = COT and REQ = NEW.
PROG Progress euroisdn-22
NCHG Send a PROGRESS signal when a CALL
PROCEEDING message which contains a progress
Indicator Information Element is received at the
Meridian 1 EuroISND gateway.
NCHG is the default for all interfaces except Australian
and Austrian. NCHG is not supported with Japan
interface.
MALE Send an ALERT signal when a CALL PROCEEDING
message which contains a progress Indicator
Information Element is received at the Meridian 1
EuroISND gateway.
MALE is the default for Japan interface.
MCON Send a CONNECT signal when a CALL PROCEEDING
message which contains a progress Indicator
Information Element is received at the Meridian 1
EuroISDN gateway.
MCON the default for Australian and Austrian interface.
553-3001-311 Standard 6.00 June 1999