05.02.2013 Views

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

SS12 SYS-12 for Norway<br />

SWIS SwissNet for PRI2 (SN2)<br />

TCNZ Tele<strong>com</strong> New Zealand (NEAX-61)<br />

LD 16<br />

Alphabetical list of prompts Page 375 of 1050<br />

Prompt Response Comment Pack/Rel<br />

IHT 2-(30)-62 Outgoing Calling Party Control call disconnect after the<br />

far end disconnects.<br />

Number of seconds in increments of two after which an<br />

in<strong>com</strong>ing Calling Party Control call will disconnect after<br />

the far end disconnects.<br />

ILLR ic dc Illegal Ring threshold. Where:<br />

• ic = increment count = 0-(2)-15<br />

• dc = decrement count = 0-(2)-15<br />

ILLR specifies illegal ringing on a seized trunk.<br />

ILLR is only prompted for COT, FEX and WAT trunks.<br />

The increment count (ic) and decrement count (dc)<br />

control the rate at which detected failures exceed the<br />

trunk error threshold. A counter (initially set to zero)<br />

records trunk successes and failures. The counter is<br />

incremented by the IC value each time a failure is<br />

detected, and by the DC value when a valid trunk<br />

condition is detected.<br />

When the counter value exceeds the trunk threshold<br />

value (30), the overflow indicator is set, and a TRKxxx<br />

message displays. A high IC value increases the<br />

counter more rapidly than a low IC value, thus causing<br />

the counter to exceed the threshold with fewer detected<br />

failures.<br />

opcb-14<br />

basic-1<br />

<strong>X11</strong> <strong>Administration</strong>

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!