Software Input/Output Guide X11 Administration ... - paulmick.com

Page 432 of 1050 Gate Opener: ADAN (Action Device and Number)
- - VSIG (NO) YES Virtual Network Services Network Signalling option
- - DCHL 0-159 D-Channel PRI loop number
- BCHL 0-159 PRI loop number for Backup D-channel
- PRI loop x Primary Rate Interface
- PRI2 0-159 2-15 Secondary PRI2 loops for nB + D, plus sequence
- OTBF 1-(32)-127 Output request Buffers
- DRAT aaa D-channel transmission Rate (aaa = (56K), 64KC, or 64KI)
- BPS xxxxx Bits Per Second
- PARM aaaa bbb Parameters for Interface and transmission mode
(aaaa = R232 or R422 ; bbb = DCE or DTE)
- CLOK aaa Clock (aaa = EXT or INT)
- SIDE aaa Meridian 1 node type (aaa = (USR) or NET)
- SEMT (1)-5 Number of Status Enquiry Messages sent within 128 ms
from the network side
- CNEG x Channel Negotiation option (x = (1) or 2)
- RLS xx Release ID of the switch at the far end of the D-channel
- QCHID (YES) NO Map channel number to timeslots on a PRI2 loop
- RCAP aaa Remote Capabilities (RCAP options begin on page 494)
- - MQC_FEAT aaa MCDN QSIG Feature type
- - PR_RTN (NO) YES Retain option supported by the far end PINX
- - PR_TRIGS aaa xx Path Replacement Triggers
- OVLR (NO) YES Overlap Receiving
- - DIDD (0)-15 DID Delete
- OVLS (NO) YES Overlap Sending
- - OVLT (0)-8 Overlap Timer, in seconds
- MBGA (NO) YES Multilocation Business Group Allowed
- NASA (NO) YES Network Attendant Service Allowed
- TIMR (NO) YES Change protocol timer value
- - T310 10-60 Timer used to determine how long SL-1 can wait for the
response message when the QSIG outgoing call is in the U3
(outgoing call processing) state
- - INC_T306 0-(2)-240 Variable timer for received disconnect message on incoming
calls, allowing in-band tone to be heard when sent by the
network
- - OUT_T306 0-(30)-240 Variable timer for received disconnect message on
outgoing calls, allowing in-band tone to be heard when sent
by the network (entered in 2 second increments)
553-3001-311 Standard 6.00 June 1999