Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 488 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
PINX_CUST qsig-22
0-99 This customer number will be used for the DN
address translation associated with call independent
connection messages received on this D-channel.
Prompted when IFC = ISGF or ESGF.
PMCR Number of call registers used for PMSI. pms-19
5 Minimum number of call registers to be configured
is 5
(x) The lesser of either 60 or 25 percent of the total
system call registers
y The lesser of either 250 or 25 percent of the total
system call registers
For example, if you enter 65, but 25 percent of the
system total is 45, the number entered by the system
will be 45.
PMIN (NO) YES Minor alarm when the PMSI link is not responding.
This is not prompted if XTMR = 0. When this prompt
is Yes, the attendants minor alarm is activated when
the PMSI link does not respond. Note that when the
link responds again, the alarm is not cleared.
553-3001-311 Standard 6.00 June 1999
pms-19
PMSI (NO) YES Modify Property Management Systems parameters pms-19
This is prompted is Property Management Systems
Interface (PMSI) is enabled.
PORT Port number for MSDL cards, Option 81 I/O devices,
or PMSI ports:
0-1 Port number for the CP card
0-3 Port number for the MSDL card
0-7 Port number for Pseudo TTYs
0-15 In Release 19 and later, this prompt appears for
Property Management Systems Interface (PMSI)
port configuration.
Prompted only when CTYP = MSDL (Multi-purpose
Serial Data Link), CPSI (Option 81 CP card), or PTY
(Option 81 Pseudo TTY).
Port number for Option11 systems:
0-1 Option 11 TDS/DTR Port number
basic-19