05.02.2013 Views

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

LD 16<br />

Page 366 of 1050 Alphabetical list of prompts<br />

Prompt Response Comment Pack/Rel<br />

DRNG (NO) YES Japan Distinctive Ringing drng-9<br />

DSBL (0)-100 Percentage of trunks to be disabled if loss or noise<br />

reaches the out-of-service limit<br />

553-3001-311 Standard 6.00 June 1999<br />

atm-7<br />

DSEL Data Selection basic-19<br />

(VOD) Voice or Data route<br />

DTA Data-only route<br />

TDN Transparent Data Network<br />

VCE Voice-only route<br />

3DTA Data route and 3.1 kHz<br />

3VCE Voice route and 3.1 kHz<br />

7VOD Route supports voice or data calls and the telephony 7 euro-24<br />

khz/Video telephony teleservices<br />

7DTA Route supports data calls and the telephony 7<br />

khz/Video telephony teleservices<br />

Prompted if DGTP = DTI, DTI2 or JDMI.<br />

DSPD Real Time Advice Of Charge Display isdn-22<br />

(NO) Do not display charge information during call<br />

YES Display charge information during call<br />

DSPD applies to Aries sets (M2006, M2008, M2016,<br />

M2216, and M2616) on a per route basis. To activate<br />

this feature, the prompt MR must be set to either DURC<br />

or ENDC.<br />

DSPT 0-(10)-60 Charge Display Timer in seconds<br />

DSPT determines how long charge information is<br />

display at the end of the call.<br />

isdn-22<br />

DTD (NO) YES Dial Tone Detection dtd-10<br />

DTDF x y Dial Tone Detector Fail threshold. Where:<br />

• x = increment threshold = 1-(2)-15<br />

• y = decrement threshold = 1-(2)-15<br />

DTOC (NO) YES Direct Toll Connection<br />

dtd-10<br />

DTOS (NO) YES Dial Tone on Outgoing Seizure dass2-16<br />

Prompted if SIGL = DAS.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!