Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 358 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
CDCT (NO) Called Party Control is not enabled on incoming calls
when MFC IDCT signal is sent
YES Called Party Control is enabled on incoming calls when
MFC IDCT signal is sent
CDPC (NO) Called Party Control is not enabled when MCT feature
is activated.
YES Called Party Control is enabled when MCT feature is
activated.
Prompted when OPCB = YES
553-3001-311 Standard 6.00 June 1999
opcb-14
supp-14
CDR (NO) YES Call Detail Recording cdr-1
Set and change CDR options for this route.
CDRB (NO) YES Abandoned call on busy tone records. cdr- 23
CDRX (NO) YES Print CDRX records on multiple call transfer for
non-PPM outgoing calls.
This prompt appears if CDRX package is equipped and
MR is not equal to PPM. Also CDR = YES, TKTP =
COT or DID for International DID/DOD and ICOG
cannot be ICT.
CDRY (NO) YES CDR Public Network Feature Invoke records will be
generated
cdrx-20
ddsp-20
CFWR (NO) YES Call Forward Restriction supp-10
CGPC (NO) Calling Party Control on incoming calls on this route is
not enabled
YES Calling Party Control on incoming calls on this route is
enabled
CHRG (BLOK) A DOD Call over this MFK route must signal the CO
that it wishes to be charged by block.
LINE A DOD Call over this MFK route must signal the CO
that it wishes to be charged by line.
opcb-14
kd3-20
CHTY Channel Type pra-12
(BCH) B-channel
ABCH A/B bit signaling
Prompted when DTRK = YES, ISDN = YES and
Mode = PRA.