Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 401 of 1050
Prompt Response Comment Pack/Rel
ROUT Route number basic-1
0-127 This range applies for all machines.
0-511 This range applies for machines NT, RT, NT, STE and
XT and for Options 21E, 51, 51C, 61, 61C, 71, 81 and
81C.
In X11 Release 14 and later, route 31 is no longer
reserved as a Private route but can be configured as
one.
RPA (NO) YES Radio Paging Route rpa-20
If this prompt is set to NO, the route is not allowed to be
used for Radio Paging. Prompted with Radio Paging
(RPA) package 187 and TKTP = TIE or COT.
RPPM Real-time Periodic Pulse Metering polling time
(in seconds)
(0) Real-time Periodic Pulse Metering will not operate
10-250 1-9 Rounded up to 10
251 Rounded down to 250
pedm-16
RRBS Repeat Release Before Seize pedm-18
(NO) Seize the trunk normally.
YES A release signal will be sent followed by the seize
signal.
RRBS allows a FRLS signal to be sent immediately
before a SEZ signal on a DTI2 trunk. RRBS is
prompted if DTRK = YES, DGTP = DTI2 and FRRS
is not set to YES.
RTN 0-511 Route Number for any configured ISA route pra-12
Prompted if TKTP = TIE.
X11 Administration