Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 496 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
NAC Network Access data. Enter XNAC to remove NAC
as a remote capability. NAC is allowed if:
• the D-channel is defined on an MSDL card
(i.e. CTYP=MSDL)
• the D-channel interface type is SL1 (IFC=SL1)
• software release of remote end is x11 release
22 or greater (RLSŠ22)
NCT Network Call Trace supported
ND1 Network Name Display method 1
ND2 Network Name Display method 2
ND3 Network Name Display method 3. ND3 ensures the
same level of service between the MCDN and QSIG
name display services.
NDI Name Display - Integer ID Coding qsig-24
NDO Name Display - Object ID Coding qsig-24
NDS Name Display Services
Add Path Replacement as a remote capability. Only
one capability can be configured per link.
PRI The encoding method uses Integer Values.
PRO The encoding method uses Object Identifier.
Precede with ‘x’ to remove capability.
RVQ Remote Virtual Queuing
RCAP is prompted until only is entered in
response. Precede a value with X to remove.
ND1 and ND2 are used with Network Call Party
Name Display or NCPND. Both ends must have
NCPND.
ND1 requires Release 13 and later. ND2 requires
Release 17 and later; or SL-100, DMS with BCS32
and later. RVQ requires Remote Virtual Queuing
(ORC_RVQ) package 192.
TAT Invoke Trunk Anti-Tromboning operation if the
far-end switch also supports this feature.
TAT may be input if: TAT package is equipped,
CTYP = MSDL, IFC = D100, SL1, S100 or D250.
553-3001-311 Standard 6.00 June 1999
qsig ss- 23