Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 380 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
553-3001-311 Standard 6.00 June 1999
For example, if MAX = 8 for Tie routes, no more than 8
channels can used simultaneously for Tie calls.
Prompted when:
1. ISAR = YES and IFC = ESS4, or
2. NSF = YES and IFC = SL-1 or D100 for the
selected ISA route defined by response to RTN
prompt.
MBGA (NO) YES MBG Interface on the D-channel brit-18
Prompted if Network Tenant Service feature active.
MCCD 0- 8 The call trace request string can be 0-8 digits in length. emct-20
Valid digits are 0-9, *, #.
MCDT (0)-4 Digit string delay time is in seconds. emct-20
Granularity is 1 second.
MCTM (0)- 30 Malicious Call Trace request timer id (in seconds)
This is the disconnection delay which is used when the
far end goes on hook. Granularity is 1 second.
Prompted if interface type for the D channel is AXE-10
Australia.
mct-10
MCTS (NO) YES Malicious Call Trace Signal emct-20
MDMP Modem Data Module Pair adm-5
(NO) ADM only route
YES Modem Data Module Pair route
MDTD 1-(5)-31 Minimum Dial Tone Detection delay dtd-10
MFC Multifrequency Compelled (MFC) Signaling mfc-9
(NO) No MFC Signaling
YES Multifrequency Compelled or MFC Signaling
CMFS CIS MFS route. This response is allowed only if both
the CIST and CSMFS packages are equipped and only
for the outgoing CO DTI2 routes and for the incoming
cismfs-23
DID DTI2 routes.
MFE Multifrequency Compelled Signaling for Socotel mfe-10
MFK5 2/5 Spanish KD3 MF Signaling kd3-20
MFK6 2/6 Spanish KD3 MF Signaling kd3-20