Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 368 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
EQAR (NO) YES Enable Equal Access Restrictions eqa-17
Prompted when TKTP = CO, FEX, WAT, or ISA,
and ICOG = OGT, or IAO.
ESN (NO) YES Electronic Switched Network pad control for NT8D15
XEM card.
This only applies to trunk routes whose members may
use 4-wire E&M or DX signaling on an Electronic
Switched Network. This prompt is the replacement for
the ESN switch setting on the QPC237 circuit card.
When YES is selected, a 1 dB improvement in loss
levels is provided on trunk to trunk calls using the
NT8D15 units.
Prompted with Network Alternate Route Selection
(NARS) package 58 and Meridian 1 Extended
Peripheral Equipment (XPE) package 203.
553-3001-311 Standard 6.00 June 1999
xpe-15
FACY Facility indicator for Private or TIE connection. isa-17
(NO) Tie connection in the NSF IE
YES Private connection in the NSF IE
Prior to Release 17, all tie trunks to a DMS-250 sent a
Private facility value, all others sent TIE. In Release 17,
trunk routes to a DMS-250 automatically have FACY
set to YES. All others default to NO.
FACY is prompted when TKTP = TIE, ISAR = YES, and
IFC = D100, D250 or S100.
FALT (NO) YES Recognition of DTI2 ABCD FALT signal for ISL pedm-18
Prompted for DTI2 ISL routes.
FEDC Far End Disconnect Control
This entry should correspond to the type of disconnect
control used by the far end apparatus of this trunk
route. Loop start trunks may be assigned either ORG or
ETH.
(ORG) Originating end control
The apparatus recognizes conditions on the near end
only for calls originated by the Meridian SL-1. This does
not allow trunk to trunk connections.
basic-1