Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 384 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
MTND (NO) YES Malicious Call Trace Tandem Disconnect delay for
AXE10 interface
If set to YES the disconnect operation is delayed at the
node closest to the CO for up to MCTM time when the
call is a tandem call.
553-3001-311 Standard 6.00 June 1999
emct-20
MULT Multiplier for Charge Information isdn-22
(NO) Do not change calculation of charge information.
YES Provide the exact cost of charge information if the
RURC exponet is configured to the value of the
multiplier.
Your response to MULT should be YES when the
Central Office sends charge information in one
hundreth of currency and the currency multiplier is less
than 1. The multiplier exponent should be equal to the
RURC exponent. This is only used with functional
protocol.
MUS (NO) YES Music on Hold mus-1
MXTI 0-(5)-15 Maximum Time to wait for the far end to connect to test
line (in seconds)
atm-7
M911_ABAN Meridian 911 Call Abandon m911-21
(NO) Abandoned call treatment is not used on this route
YES Abandoned call treatment is used on this route
M911_ANI (NO) YES Receive ANI for Meridian 911 routes.
The M911_ANI prompt acts as a gate opener for
Meridian 911 prompts and should always be YES.
Prompted with Meridian 911 (M911) package 224 and
TKTP = DID. Applies to Release 19 and later.
m911-19
M911_TONE Meridian 911 Tone m911-21
(YES) Tone given on answer
NO Tone not given on answer
M911_TRK_TYPE Meridian 911 ANI trunk types m911-19
(T911T) E911 tandem connections
911E End office connection