Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 376 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
553-3001-311 Standard 6.00 June 1999
The threshold counter only preserves positive values. If
the counter contains a negative value, it automatically
resets to zero. The next detected failure immediately
increases the counter toward the threshold value,
enabling quicker trunk failure detection.
ic dc = threshold percentage
• 41 = 20%
• 21 = 33%
• 32 = 40%
• 22 = 50%
• 24 = 67%
• 13 = 75%
• 14 = 80%
• 17 = 88%
The RSET command in LD 36 and LD 41 resets the
threshold counters to zero.
IMBI (NO) YES Immediate Break-In opcb-14
Line signal is required before Break-In.
Prompted when MFC = R2MF, MFCI = a valid MFC
table.
IMCB (NO) YES Immediate Call Back opcb-14
Desired party will be re-rung if IMCB = YES. Prompted
when MFC = R2MF, MFCI = a valid MFC table.
INAC (NO) YES Insert ESN Access Code to incoming private network
call
INAC permits an ESN access code to be automatically
added to an incoming ESN call from a private network.
If INAC = YES, then digit insertion (INST) for NARS or
BARS calls is bypassed and Access Code 1 (AC1) is
used for all call types. However, calls may be
specifically defined to use Access Code 2 (AC2) in
LD 15 at the AC2 prompt.
INAC is prompted when the route type is either a TIE
trunk or an IDA trunk with DPNSS1 signaling.
pra-21