Software Input/Output Guide X11 Administration ... - paulmick.com

LD 11
Alphabetical list of prompts Page 163 of 1050
Prompt Response Comment Pack/Rel
xx SCR yyyy (ccc or D) zz..z basic-20
Single Call Ringing key
Where:
• yyyy = DN
• ccc = CLID entry of (0)-N, where N = the value
entered at the SIZE prompt in LD 15 minus 1.
• D = the character D may be entered to search a
CLID entry from key 0 and up to find a DN key.
The CLID associated with the found DN key will
then be used.
• zz..z = additional information required for the key
aaa. For Release 24 and later.
The DN can be up to 4 digits, up to 7 digits with Directory
Number Expansion (DNXP) package 150. Use a single
appearance DN to terminate VCC Voice Call or SIG
Signaling calls.
With Release 18 and later, once the SCR key has been
defined, MARP is prompted.
On the M3901, M3902, key 0 is reserved for SCR. basic-24
xx SCU yyyy optf-1
Speed Call User key
Where: yyyy = SCL list number = 0-253 prior to
Release 13, 0-8190 in Release 13 and later. SCL must
be defined in LD 18.
On the M3903, M3904, M3905, key 23 is reserved for basic-24
SCC, SCU, SSU, SSC or NUL.
xx SIG yyyy Signal key
Where: yyyy = Single appearance DN.
The DN can be up to 4 digits, up to 7 digits with DNXP
package 150. Key/lamp is not required.
basic-1
xx SSC yyyy optf-1
System Speed Call controller key
Where: yyyy = SSC list number = 0-253 prior to
Release 13, 0-4095 in Release 13 and later. SSC list
must be defined in LD 18.
On the M3903, M3904, M3905, key 23 is reserved for basic-24
SCC, SCU, SSU, SSC or NUL.
X11 Administration