Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 482 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
NCPU 1-(2) Number of CPUs
This value is normally programmed at the factory.
For System Option 51 set the number of CPU to 1
and define the extenders as EXT0 0 NIL 3PE and
EXT1 0 NIL 3PE.
With Release 18 and later, this is prompted for NT,
RT, 51 and 61 systems only. XT and 71 systems
automatically have 2 assigned. Options 11, STE and
21E systems have 1 assigned.
NCR xx Number of Call Registers, range depends on system
type. Where:
• xx = 26-2047 for System Option 21 and 51
• xx = 26-5000 for System Option 71 and SL-1
XT
• xx = 26-20000 for System Option 81
The maximum number of call registers may be
limited by the amount of system memory. In this case
the number of call registers is the amount of
protected memory available divided by the number
of words per call register.
Refer to the Memory Calculations Appendix in the
Planning and Engineering NTPs.
NDCH 0 - 63 Move the primary D-channel to this logical number.
With X11 release 18 and later, the ADAN MOV
command is supported for D-channels.
NDIS (20)-255 Number of Display messages for the Background
Terminal (BGD).
The NDIS entry determines the queue length for
display messages for the BGD application.
553-3001-311 Standard 6.00 June 1999
basic-18
basic-19
pri-18
bgd-10
NDRG (NO) YES New Distinctive Ringing drng-10
Prompted if Distinctive Ringing (DRNG) package 74
equipped, and if packages ATVN 68, FTC 125 and
JTDS 171 are turned off.