Software Input/Output Guide X11 Administration ... - paulmick.com

LD 56
Alphabetical list of prompts Page 759 of 1050
Prompt Response Comment Pack/Rel
CAST (NO)YES Centralized Attendant Service Tones
Modification to the CAS (Centralized Attendant Service)
tone definition.
For systems with XCT (NT8D17 Conference/TDS)
cards, each feature requires a firmware cadence
(XCAD), a software cadence (CNDN) and tone (XTON).
Due to the finer resolution of the firmware cadence (5
ms) compared to the software (96/128 ms), you should
allow the software cadence to be long enough to cover
the full duration of the XCAD.
For example, to define a cadence of 0.1 s on, 0.1 s off,
0.1 s on, steady off
• CDNC0020 0020 0020 0000
• END OFF
• SPCL
The software cadence is then 0.3 s (600 ms). If the
software precision is 128 ms, the software cadence is
calculated as follows:
• 600 ms/128 = 4.6 = 5 (rounded up)
• 128 x 5 = 640
Entry to on phase = 640/5 = 0128, and to define the
cadence enter 0128 to prompt CDNC.
ftc-13
CDNC xxxx xxxx ... xxxx
On-off phases for Cadence (ten on-off cycles)
Entries 1 through 15 are reserved for ringing cadences.
When defining the cadences in MCAD each phase entry
is in 5 millisecond increments.
The range for the first phase is 1-9999 increments.The
range for the second phase is 0-9999 increments. The
default is 0 0 0 0 0 0 0 0 0 0.
Table shows the default MCAD Tables.
ftc-14
0-(16)-255 MCAD software cadence number ftc-14
0-(17)-255 MCAD software cadence number
0-(19)-255 MCAD software cadence number (see Note 5)
X11 Administration