Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 367 of 1050
Prompt Response Comment Pack/Rel
DTPI (*67) nnnn Privacy indicator for a digitone trunk
Any arbitrary digit (0-9) sequence up to 4 digits can be
specified. Only the first digit may be an asterisk (*). If
CPP prompt is changed from NO to YES and is
entered, DTPI defaults to *67.
DTPO (*82) nnnn Privacy Override indicator for a digitone trunk.
nnnn = Any arbitrary digit (0-9) sequence up to 4 digits
in length. The Asterisk (*)can only be entered as the
first digit.
DTPO is defaulted to *82 if CPP is changed from NO to
YES and is entered
DTR Data Terminal Ready. Prompted if TKTP = R232 or
MCU.
(OFF) DTR lead follows state of the lead on the device to
which it is connected
ON DTR lead always forced active
DTRK (NO) YES Digital Trunk Route.
Prompted with PBX Interface for:
• DTI/CPI (PBXI) pkg 75
• 2 Mbit Digital Trunk Interface (DTI2) pkg 129
• Japan Digital Multiplex Interface (JDMI) pkg 136
• ISDN Primary Rate Access (PRA) pkg 146, or
• 2 Mbit Primary Rate Interface (PRI2) pkg 154
cpp-21
cpp-23
basic-18
DTYP (IOP) Inbound/Outbound Data Port amp-5
IDP Inbound Data Port
ODP Outbound Data Port
DUP Duplex for data port basic-18
(FULL) Full duplex
HALF Half duplex
Prompted if TKTP = MCU.
EML 0-15 Expected Measured Loss (in dB) atm-7
EOS (NO) No End-of-Selection signal on DID routes supp-10
YES End-of-Selection signal is enabled
BSY EOS and busy signals are enabled
dti-5
X11 Administration