Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 450 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
BCAP Bearer Capability euroisdn-22
(SPEECH) Speech
3.1 KHZ 3.1 KHZ
BCHI 1-15 Backup D-channel port number. pri-12
Precede with “X” to remove.
BCHL 0-159 PRI loop number for Backup D-channel. Prompted
when ADAN = BDCH.
1-9 Option 11 PRI loop number (non-D70)
Precede with X to remove.
553-3001-311 Standard 6.00 June 1999
pri-12
BCST (NO) Only this broadcast port is affected by flow control basic-18
YES All broadcast ports of the same user type are
affected by flow control.
Use this prompt with caution. For example, if
BSCT = YES, and a maintenance port receives an
X-off command, system output to all maintenance
ports will eventually be blocked.
This prompt appears only if FLOW = YES. BSCT is
not prompted for TTY_TYPE = LSL.
BITL (5), 6, 7, 8 Bit length. Prompted for asynchronous ESDI ports.
For Option 11C, BITL is not prompted for
CARD 0 PORT 0 or when TTY_TYPE = PTY.
cls-7
BKGD 30, 33, 34, 35, 36, 37, 38, 40, 41, 43, 44, 45, 46, 53 basic-1
Background overlay task
Enter the diagnostic program number 30, 33 and so
on, to run in background when the overlay area is
idle.
With Release 12, the customer may configure more
than one overlay to be run in background. These
overlays will run sequentially, one after the other.
The data dump routine LD 43 should be reserved for
the DROL to preserve data integrity. Programs 33,
45, 46 and 53 are not applicable to Option 11.