Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 352 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
AIOD (NO) YES Identification of outgoing calls aiod-1
ALRM (NO) YES Malicious Call Trace Alarm is allowed for external calls mct-10
ANDN 0 - 9999999 ANI DN
ANDN is used for building ANI messages. ANDN is
prompted if Commonwealth of Independent States
(CIST) package 221 is equipped.
ANDN is not prompted if the route is outgoing only
(ICOG = OGT) and TKTP is not COT (for analog trunks,
not DID).
553-3001-311 Standard 6.00 June 1999
Incoming route:
If ANDN is defined, it will be used as ANI DN in CDTI2/
CSDTI2 ANI messages when this incoming trunk is the
originator of an outgoing CDTI2/ CSDTI2 call. If ANDN
is not defined, the the ANDN of the outgoing CDTI2/
CSDTI2 trunk is used.
Outgoing route:
Default ANI DN in CDTI2/ CSDTI2 ANI messages.
If the ANI DN of the call originator cannot be used, then
ANDN for the outgoing CDTI2/ CSDTI2 route is used.
This will happen for sets with CLS DNAD and for
incoming routes if ANDN is not defined.
May be from 0 up to the ANSZ length.
Prompted for outgoing CIS route.
Used for building ANI message if ANIC=NO and DN of
set is not allowed to be sent (CLS DNAD).
Also used if ANIC=YES but the ANI entry associated
with the originator of the call is not configured, and DN
of set is not allowed to be sent (CLS DNAD).
X Remove ANDN
cist-21
cist-24
ANDT (NO) YES Automatic Number Identification Dial Tone ani-1