Software Input/Output Guide X11 Administration ... - paulmick.com

LD 27
Alphabetical list of prompts Page 701 of 1050
Prompt Response Comment Pack/Rel
If REQ = PRT, entering:
• l: prints out information for all cards on this loop
• l s: prints out information for all cards on that loop
and shelf
• : prints out information for all system cards
• card: prints information for this card (Option 11
only)
l s c u Terminal Number
loop ch PRI loop and B-channel number
1-20 Option 11
TRANS (NO) Restrict presentation of COLP, CLID coming from S0
terminal without presentation option
If TRANS = NO and if the presentation indicator is set
to restricted, the number digits are erased from the
information element before it is sent to the S0 terminal.
YES CONNECTED NUMBER IE received from the
Meridian 1 is sent transparently to S0 terminal, even if
restricted
bril-22
TRMT Terminating Type bri-20
D D-channel terminal type configuration used
B B-channel terminal configuration type used
TSET 0-15 Threshold Set for clock errors tset-7
TYPE Type of data block bri-19
BRSC BRI Signaling Concentrator (Rel 19 and later)
CARD S/T (SILC) or U (UILC) Interface Line Card data block
DNAT Data Network Address Tables (Rel 19 and later)
DSL Digital Subscriber Loop data block
LAPB Link Access Protocol on B-channels (Rel 19 and later)
LAPD Link Access Protocol on D-channel (Rel 19 and later)
MISP Multi-purpose ISDN Signaling Processor data block
X11 Administration