Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 490 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
loop x Enter loop number for additional PRI loops using the
same D-channel and the interface ID for the
additional loop numbers. Where:
• loop = 0-159 for PRI loop number
• x = 2-15 for Interface ID or 1-126 if IFC= D70
or CNTY = JAPN
The PRI prompt is used to assign the PRI loops
controlled by the D-channel. Each loop is given an
Interface ID.
The PRI loop carrying primary D-channel (DCHI)
and backup D-channel (BCHI) are assigned an
Interface ID 0 and 1, respectively. The 14 remaining
PRI loops that can be assigned to the D-channel are
defined here and given an Interface ID of 2-15.
card x Option 11
Where:
• card = 1-9 for PRI card number
• x = 2-15 for Interface ID or 1-126 if IFC= D70
or CNTY = JAPN
Precede with X to remove. This prompt is repeated
until is entered.
PRI2 0-159 2-15 Secondary PRI2 loops for nB + D, plus sequence,
when IFC = SL-1 and DCHL is a PRI2 loop.
card 2-15 Option 11 Secondary PRI2 loops for nB + D, plus
sequence, when IFC = SL-1 and DCHL is a PRI2
loop.
Where:
• card = 1-9 for PRI card number
0-159 0-3 Secondary PRI2 loops for nB + D, plus sequence,
when IFC = TCNZ or CNTY = MSIA. The D-channel
is not necessarily on IFC ID 0. This is set by service
change.
xx 0-3 Option 11 when IFC=TCNZ and or CNTY=MSIA.
Where:
• xx = 1-9 for PRI card number
553-3001-311 Standard 6.00 June 1999
ipra-14