Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts Page 503 of 1050
Prompt Response Comment Pack/Rel
T203 2-(10)-40 Maximum Time allowed without frames being
exchanged
Prior to Release 18.30H the default was 5 seconds,
(.5 second units). With Release 18.30H and later the
default is 10 seconds, (1 second units).
pri-15
T23 1-(20)-31 Interface guard Timer or DCHI only pri-12
This timer checks how long the interface takes to
respond. Entry is in units of 0.5 seconds.
T3 2-(5)-255 Timer for initial link setup in units of 0.5 seconds for
ESDI only.
T310 Timer used to determine how long SL-1 can wait for
the response message when the QSIG outgoing call
is in the U3 (outgoing call processing) state.
10-(30)-60 Timer range prior to Release 22. Default = 30
seconds for QSIG. Default = 10 seconds for TCNZ.
110-(120) Timer range for Release 22. This range applies to
PRI, PRI2, and BRI trunks in Release 22.
TDS 0, 2, 4…158 Tone and Digit Switch (TDS or Fast TDS service
loop)
Use even-numbered loops for Tone and Digit Switch
(TDS). Precede with X to remove.
1-9 Option 11
0-10 Option 11 with System Core Circuit card
1-9 11-19
21-29 31-39
41-49
Option 11C (Release 24)
Note: For Option 11C, all XTD/DTR units must be
removed from the SSC card (card 0) before TDS 0 can be
removed.
cls-7
qsig-20
basic-1
TEN xxx Tenant to be accessible by way of PWnn lapw-16
ALL All Tenants allowed
No change to previous definitions.
Precede with X to remove.
X11 Administration