Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 381 of 1050
Prompt Response Comment Pack/Rel
MFCI 1-127 MFC Incoming table number mfc-9
Where 0 = Remove outgoing table
MFCO 1-127 MFC Outgoing table number mfc-9
Where 0 = Remove outgoing table
EMGY (NO) YES Emergency Route basic-24
MFEA (YES) NO Access code signals are used in the signaling mfe-10
MFED 0-(1)-9 First digit of special service call mfe-10
Precede with X to remove.
MFEI (0)-127 MFE table number for Incoming calls mfe-10
Where 0 = Remove incoming table
MFEO (0)-127 MFE table number for Outgoing calls mfe-10
Where 0 = Remove outgoing table
MFKI 1- 127 MFK table number for Incoming calls kd3-20
MFKO 1- 127 MFK table number for Outgoing calls kd3-20
MFSS (B1) B2 B3 Specifies the first MFS digit request backward signal
used by the incoming CDTI2-MFS trunk for the
requesting the next digit from the outgoing CIS CO
party. The MFSS is prompted only if the MFC is set to
CMFS only for incoming routes.
MIN 0-254 Minimum number of channels allowed on the ISA route,
service dependent
0-510 With Release 24
For example, if MIN = 2 for Tie routes, at least two
channels will be available for Tie calls.
Prompted when:
• ISAR = YES and IFC = ESS4
• NSF = YES and IFC = SL1 or D100 for the
selected ISA route defined by response to RTN
prompt.
cismfs-23
isa-12
MOD (NO) Network Mode for synchronous operation basic-18
YES Modem Mode for synchronous operation
Prompted if TKTP = MCU and TRAN = SYN.
X11 Administration