Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 413 of 1050
Prompt Response Comment Pack/Rel
Software controlled Centrex/Trunk Switch Flash timer
range of 60- 127 msec is done by sending digit 1.
The range of 128-1536 msec is already controlled by
Centrex Switchhook Flash feature.
Firmware flash user can enter any value from 60 to
1536.
FWTM must be YES in LD 14 for the trunk associated
with this route, if firmware timing is to be used.
GRD 0-(896)-32640 basic-1
Guard timer (response disallowed)
GTI 0-(896)-32640 xct1-16
Incoming Guard timer (ms)
For DTI2 trunk routes, guard timer of 0 may be defined
(meaning that timing is not necessary).
An Incoming Guard Timer on the ISPC SLAVE side
(when SMAS = NO) must be set to 0.
GTO 128-(896)-32640 xct1-16
Outgoing Guard timer
ICF 0-(512)-32640 basic-1
Incoming Flash timer
IENB 2-(5)-10 nas-18
Idle Extension Notification Block timer (in minutes)
Semi-Automatic Camp-On (SACP) package 181 and
Network Attendant Services (NAS) package 159 must
be equipped.
LCT 0-128-32640 basic-1
Loop Calling detection timer
Default for COT trunks = 128
Default for all others trunks = 256
LEXT 50-(100)-350 tip-19
Loop Extender timer (timer is in milliseconds)
The minimum amount of time the Meridian 1 waits to
determine whether the tip is ground. When the time is
expired, the loop is closed to outpulsing.
X11 Administration