05.02.2013 Views

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

Software Input/Output Guide X11 Administration ... - paulmick.com

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

LD 16<br />

Page 370 of 1050 Alphabetical list of prompts<br />

Prompt Response Comment Pack/Rel<br />

FRRC 0-(4)-15 Forward Release Repetition Count<br />

This represent the number of times a Forward Release<br />

signal is resent before an error message is printed, if an<br />

acknowledgment is expected but not received.<br />

The length of time the software waits for<br />

acknowledgment before re-sending the signal is given<br />

by the Disconnect Supervision timer.<br />

Prompted if FRIN = YES.<br />

553-3001-311 Standard 6.00 June 1999<br />

pedm-18<br />

FRRD 128-(384)-1920<br />

Forward Release Repetition Delay in milliseconds<br />

This is the delay between sending the seize message<br />

and the Forward Release. The accuracy of this timer is<br />

governed by the accuracy of the 128 millisecond timing<br />

queue.<br />

Prompted if FRIN = YES and FRRS = YES.<br />

pedm-18<br />

FRRS Forward Release Repetition Seize pedm-18<br />

(NO) Do not re-seize the trunk before re-sending the Forward<br />

Release.<br />

YES Re-seize the trunk before re-sending the Forward<br />

Release.<br />

Prompted if FRIN = YES.<br />

GCR (NO) YES General Carrier Restriction to restrict Equal Access<br />

calls. Not prompted for Release 20 and later.<br />

eqa-19<br />

GRD Ground Start Arrangement ranbrd-23<br />

(IDLE) RAN machine send ground signal when idle. ran-23<br />

PLAY RAN machine send ground signal when playing.<br />

HDLC (NO) YES High level Data Link Control basic-18<br />

Prompted if TKTP = MCU and V25 = YES.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!