Software Input/Output Guide X11 Administration ... - paulmick.com

LD 11
Page 144 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
KEY xx aaa yyyy (ccc or D) zz..z
Telephone function key assignments
The following key assignments determine calling options
and features available to a telephone. Note that KEY is
prompted until just a carriage return is entered.
Where:
• xx = key number
• aaa = key name or function
• yyyy = additional information required for the key
• ccc = CLID entry of (0)-N, where N = the value
entered at the SIZE prompt in LD 15 minus 1.
• D = the character “D”. When the character “D” is
entered, the system searches the DN keys from
key 0 up to find a DN key a CLID entry. The CLID
associated with the found DN key will then be
used.
• zz..z = additional information required for the key
aaa. For Release 24 and later.
With X11 Release 23, ISDN is not required for Calling
Line Identification entry.
basic-1
553-3001-311 Standard 6.00 June 1999
Note: The position of the (ccc or D) field varies depending on
the key name or function.
You may enter a CLID entry if aaa = ACD key, HOT d,
HOT L, MCN, MCR, PVN, PVR, SCN or SCR. Type xx
NUL to remove a key function or feature.
Some data ports require specific key assignments. Refer
to the Meridian Data Services NTPs for information
regarding these requirements.
Key number limits that can be assigned are as follows:
• 0-5 for M2006
• 0-7 for M2008
• 0-59 for M2616, varies with number of add-on
modules
• 0-69 for SL1, varies with number of key/lamp
strips