Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts Page 501 of 1050
Prompt Response Comment Pack/Rel
(50)-1500 Word Size of Audit Trail buffer lapw-16
The Size entered here must be a multiple of 50 for
correct memory storage.
SL1B 16-2048 SL-1 Buffers basic-1
Option 11 does not require SL-1B buffers. If set
higher than default they only consume memory.
Refer to the Memory Calculations Appendix in the
Planning and Engineering NTPs.
SMEM (NO) YES Short Memory test smem-19
On a manual SYS load the memory is tested on one
pass, if (NO), memory is tested with normal six pass
test. Not prompted on Options 81 and 81C.
SOLR 0-(1)-4 Sidetone Objective Loudness Rating
The SOLR value is downloaded to Meridian Modular
telephones after sysload except when performing
parallel reload.
Before changing these values, refer to the Summary
of Transmission Parameters NTP and the
International Loss and Level Plan planning and
engineering NTP.
(1) 12 dB
0 7 dB
2 17 dB
3 22 dB
4 sidetone disabled
The default is 0, indicating no change to the default
+45 dB. The number entered in this field
corresponds to an offset value.
The default value for Release 14 and 15 is 0 (7 dB).
The default value for Release 16 and later is 1
(12 dB). The recommended North American value
for all releases is 1 (12 dB). Does not apply to
M2216.
arie-14
SSDT 0-159 Standby Synchronization DTSL basic-16
Enter the number of the DTSL used for Standby
Synchronization. Prompted if SYNM = 2 or 5.
X11 Administration