Software Input/Output Guide X11 Administration ... - paulmick.com

LD 11
Alphabetical list of prompts Page 139 of 1050
Prompt Response Comment Pack/Rel
DTMK x...x Data Mode Key number for a dynamic voice/data TN.
DTMK is prompted if the TN has both CLS = VCE and
CLS = FLXA. There can be only one data mode key per
TN. Any response to DTMK will overwrite a previous
setting.
When changing from CLS = DTA to CLS = VCE,
CLS = WTA should also be assigned to avoid conflict
with CLS = CPTA.
Where x...x = number of the SCR/SCN key to be
designated as the data mode key. This cannot be
key 00.
No data mode key. TN is not a dynamic voice/data TN.
basic-22
DTR Data Terminal Ready settings arie-14
(OFF) Dynamic DTR
ON Forced DTR, force the data port to always be ready for
transmission.
With the Data Access Card (DAC). DTR is prompted if
TYPE = R232.
DTYP Data Station Type amp-5
(IOS) Inbound/Outbound Data Station
IDS Inbound Data Station
ODS Outbound Data Station
DUP (FULL) Full Duplex arie-14
HALF Half Duplex
ECHG (NO) YES Easy Change
This allows change to any prompt in this program
without having to through all unrelated prompts.
ECHG is prompted when REQ = CHG.
basic-12
X11 Administration