Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 512 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
XCT 0, 2, 4,...158 Extended Conference/TDS/MFS
Loop number for NT8D17 Conference/TDS/MFS
card. Enter an even network loop number for
TDS/MFS functions. The Conference function is
automatically assigned the next higher or odd loop
number.
System prints: TDS n MFS n CNF n+1
This indicates that TDS and MFS functions are
configured on the even loop “n” and conference
function is configured on the next higher odd loop.
Precede with X to remove. Both loops must be
disabled first. Since TN 0 0 0 0 cannot be used in
non-multigroup systems, it is recommended that
Conference/TDS/MFS card be placed in loop 0.
553-3001-311 Standard 6.00 June 1999
You may configure more than 16 conference loops;
however, enabling more than 16 conference loops
may cause the system to lock-up.
In multigroup systems (such as SL-1 XT and Option
71 systems) the NT8D17 should not be configured in
loop 0/1.
xct-15
D0-D158 Dealer conference loop ohol-20
S0-S158 Spare dealer conference loop ohol-20
Should be in the same group as the units planned to
use this loop.
XNUM (1)-4 Number of retransmissions per message for PMSI. pms-19
If XTMR = 0, this prompt does not appear.
XSM (NO) YES Extended System Monitor
This is the SDI port for the Extended System
Monitor. Prompt USER must be set to MTC
(maintenance messages) for the system monitor
port. Only one port can be XMS = YES.
xpe-15