Software Input/Output Guide X11 Administration ... - paulmick.com

LD 27
Page 684 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
MOB Mobility Routing Application
MPH Meridian Packet Handler
BRIL and MPH cannot operate on the same MISP.
MPH can only be deleted if there are none of the
following:
• no D-channel packet data separators
• no B-channel or D-channel terminals
• no network interface
• no PVC connections
B1 (NO) YES Change B-channel 1 configuration bri-18
When REQ = NEW B1 will not be prompted.
B1CT B-channel 1 Call Type bri-19
(VCE) Circuit switched Voice
(DTA) Circuit switched Data
PMD Packet Mode Data
IPD B-channel Packet Data with MPH
553-3001-311 Standard 6.00 June 1999
For PMD the B-channel packet data must have been
specified at the PH prompt during the MISP
configuration procedure. PMD cannot be selected
simultaneously with VCE and/or DTA.
Precede with X to remove.
B2 (NO) YES Change B-channel 2 configuration.
When REQ = NEW and B2 = NO, all B1 parameters
except for MEMB will be used as default.
When REQ = CHG, BS = NO and a change was made
to ROUT on B1, all parameters will remain unchanged
except for the route member number, which will be an
unused member. A message will be output to inform the
user of the new member number assigned.
bri-18