Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Alphabetical list of prompts Page 411 of 1050
Prompt Response Comment Pack/Rel
TIER 0-511 Tie Reference route number
Determines how incoming TIE or private call types are
handled for the associated Integrated Service Access
route or ISA. Precede with X to delete. Prompted when
TKTP = ISA, IFC = D100 or SL-1 and
NSF = YES.
TIMR aaa xxx Trunk Timers. Where:
• aaa = timer mnemonic
• xxx = timer value in milliseconds unless stated
otherwise
pra-12
basic-1
AAD (384)-2048 jpn-9
Address Acknowledge Delay timer
AAD is the minimum time for the system to delay before
sending the address acknowledge signal to the central
office. Inputs are in increments of 128 ms. Allowed only
if Japan trunks and Meridian 1 packages are equipped.
ARD 512-(1024)-2048
ANI Request Duration Timer in 256ms increments
ARP 1-(3)-255 xpe-18
Autoguard Repeat Prevention timer
Only valid for Loop start COT. Inputs are in one second
increments. International Supplementary Features
(SUPP) package 131 and Meridian 1 XPE (XPE)
package 203 required. Recommended value for
Australia is 200.
ATO 128-(4992)-6528 ani-1
ANI Time-out timer in milliseconds.
For CIS outgoing trunk routes, the ATO value defines
the time delay which follows toll access code
outpulsing. During this time delay, further outpulsing is
halted until a special card firmware message confirms
that the ANI response/request interaction has been
successful.
CRD 0-(512)-639 basic-18
CO Release Delay timer.
X11 Administration