Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts
LD 17
Alphabetical list of prompts Page 445 of 1050
Prompt Response Comment Pack/Rel
500B Output buffers for single line and digital telephones,
and trunks
16-5000 Range for Options 21, 51, 61, 71 and 81 (Release 18
& 19)
16-2048 Range for all machines (Release 20 and later)
Buffers for single line telephones, trunks and Digital
telephones
Option 11 has a value of 500 allocated by the system
and cannot be changed. These can be set higher but
have no affect on the system operation other than
consuming memory.
Refer to the Memory Calculations Appendix in the
Planning and engineering NTPs.
basic-19
ABCD (NO) YES 16-tone DTMF operation enabled abcd-14
Original value is left unchanged
ABOR 1-(5)-255 Number of aborts before an out-of-service. csl-7
Enter in units of 1, the number of aborts in 15
minutes before an out-of-service is enforced.
ADAN Action Device And Number basic-19
NEW aaa x Add I/O device. Where: aaa = type, x = port
CHG aaa x Change I/O device. Where: aaa = type, x = port
MOV aaa x Move I/O device. Where: aaa = type, x = port
OUT aaa x Remove I/O device. Where: aaa = type, x = port
Where, aaa and x can be any of the following:
1. AML 0-15 = Application Module Link
2. BDCH 0-63 = Backup primary D-channel
3. DCH 0-63 = primary D-channel (Release 18
and later)
4. FDK 0 = Floppy Disk unit, only ADAN CHG
HDK allowed (not applicable for Option 11 or
Option 81)
5. ELAN 16-31 = Application Module Link over
Ethernet
X11 Administration