Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts Page 463 of 1050
Prompt Response Comment Pack/Rel
DTCS 1-159 Digital Trunk Channel Switches (Loop numbers for
GPT hardware)
Any number between 0 and 159 is accepted for any
machine type, but not all numbers are valid. Valid
entries are as follows:
• ST = 4-15
• NT = 0-31
• XT = 0-159
Precede with X to remove. Not required for
NT5K75AA. Prompted with Integrated Digital Access
(IDA) package 122.
DTCS does not apply to Option 11.
supp-16
DTDT Dial Tone Detector Test dtd-10
NO No DTD tests are required
TDS The DTD is to be tested against a tone from the TDS
EXT The DTD is to be tested against an external source
DTI2 0-159 2.0 Mb/s Digital Trunk Interface loop number ipra-14
N0-N159 2.0 Mb/s Digital Trunk Interface phantom loop
number. Precede loop number with an “N” to
configure this loop as a phantom loop for trunks.
1-9 Option 11/11C format for DTI2 loop number
Option 11/11C format for DTI2 phantom loop
number. Precede loop number with an “N” to
configure this loop as a phantom loop for trunks.
On an Option 11C, a Phantom loop can be included
between 1-9.
Precede any DTI2 entry with X to remove.
DTIB (35)-1000 Digital Trunk Input Buffers
Required for IDA trunks. Prompted with Integrated
Digital Access (IDA) package 122. Used with
NT5K75AA DCHI operating in mode 0 or 1.
dass2-1 6
X11 Administration