Software Input/Output Guide X11 Administration ... - paulmick.com

LD 15
Data Block: MPO (Multi-Party Operations) Page 249 of 1050
Data Block: MPO (Multi-Party Operations)
Prompt Response Comment
REQ: CHG Change existing data block
TYPE: MPO_DATA Multi-Party Operations
CUST 0-99 Customer number
FMOP (NO) YES Flexible Misoperation Options
- RGNA xxx yyy Ringing No Answer treatment
- AOCS xxx yyy All Other Cases
- RCY1 1-(6)-15 Number of Cycles of Re-ringing before forwarding or disconnecting
- RCY2 1-(4)-15 Number of Cycles of Ringing before forwarding to transferring
station
- RALL (NO) YES Mandatory recall is required prior to dialing control digits
- CDTO 2-(14) Control digit timeout; in multiples of two seconds
IFLS (NO) YES Ignore Switchhook Flash signal from 500/2500 sets
MHLD (NO) YES Manual Hold after inquiry enabled
PCDS (NO) YES Programming of Control Digits required
- CNFD 0-(1)-9, *, # Control Digit for Conference
- TGLD 0-(2)-9, *, # Control Digit for Toggle
- DISD 0-(3)-9, *, # Control Digit for Disconnect
CCDO (NO) YES Consultation Connection Disconnect Option alternative treatment
AFCO (YES) NO (Automatic)/Manual Forced Camp-On
- ACNS aaa Attendant Clearing during Night Service (aaa = (NO), EXT, or ALL)
X11 Administration